Industry News
How to Evaluate a Rod End and Clevis Supplier: A Buyer’s Evidence Checklist
What should buyers check? Establish the complete configuration, manufacturing responsibilities and required evidence before comparing price. Verify whether each report is authentic, applies to the proposed item and supports the current approval decision. Record unresolved requirements and the next s......
Read More
Clevis Rod Ends: Reading DIN 71752 and ISO 8140 Dimensions Before Replacement
Can a DIN 71752 or ISO 8140 clevis replace another one? A shared standard reference helps identify a candidate; it does not settle every replacement condition. Match the selected variant, drawing revision, dimensions and tolerances, thread pitch and hand, pin retention, and required movement. Then r......
Read More
Radial Spherical Plain Bearing Codes: GE-E, GE-ES, GE-ES-2RS and GE-UK
Dongzhou's GE-E and GE-ES range uses steel-on-steel sliding contact. ES identifies the listed lubrication-groove and hole arrangement; ES-2RS adds seals on both sides. GE-UK uses a PTFE-lined sliding contact. Read these design clues alongside the complete part number and drawing, rather than treatin......
Read More
Clevis Pins and Clips: How to Choose the Right Retainer
Choose clevis pins and clips as a matched retaining system. Start with the pin diameter and assembled axial stack, then match the cross-hole, groove or dedicated clip interface. Confirm the retainer's seated position, axial retention requirement and removal access. A shared nominal pin diameter does......
Read More
Rod End Bearing Misalignment Angle: Check the Installed Joint
Rod end bearing misalignment angle describes relative tilt between the spherical inner ring and its housing under the stated catalog definition. Check that definition and the exact model drawing, then review the installed clevis, spacers, bolt and nearby parts throughout the required motion. Availab......
Read More
